View source

From Opendildonics.org

You do not have permission to do that, for the following reason:

The action you have requested is limited to users in the group uploaduser.

You can view and copy the source of this page:

'''Modifying a California Exotic Novelties' Ring of Passion&trade;'''

=Overview=

[[Image:Rop.001.xsmall.png|left]] The [http://www.calexotics.com/ California Exotic Novelties'] [http://www.calexotics.com/product.php?PRODUCTID=823 Ring of Passion] is a [[variable speed]] [[bullet]] or [[egg]] device.

In this tutorial, it will be modified to work as a simple [[on-off device]] with the speed of the bullet set manually by the user, but could be modified instead to offer variable speed control using a [[PWM]] controller.

=Procedures=

The steps involved in modifying a Ring of Passion are as follows:

==Device Preparation==

[[Image:Rop.002.small.png|right]] Open the bullet controller case and remove the wheel next to the batteries. With the wheel removed you can see how the electrical circuit is constructed. The positive battery terminal is connected to the potentiometer which then runs to the bullet.  The return from the bullet goes straight into the negative battery terminal.


[[Image:Rop.003.small.png|left]] Cut negative lead, leaving enough length on the battery side to be able to strip the wire and attach the new teledildonics wire.  If you need more wire to work with, loosen the knot on the wire pair leading to the bullet and move it toward the bullet a few centimeters.

==Splicing the Contacts==

After stripping the ends of the severed negative wire, attach your teledildonics wires and cover them with electrical tape.

Put the bullet's wire back into the slot at the end of the case and run the two teledildonics wires next to it.  The notch may need to be widened a bit depending on the gauge of wires you use.  If they're small enough, they'll fit without additional modifications.

==Connecting to your Computer==

[[Image:Rop.004.small.png|right]] Tuck all the wires under the wheel and re-attach it to the case.  Close the case and you should have a neat assembly like the one in the figure to the right.

You can now connect these leads to your computer's teledildonics interface.

=Other Thoughts=

If you'd like to interchange your devices, solder the plug end of a 2.5mm Power Plug ([[Radio Shack]] PN: [http://www.radioshack.com/product/index.jsp?productId=2103418 274-289]) to these leads and then solder a 2.5mm Phone Jack (Radio Shack PN: [http://www.radioshack.com/product/index.jsp?productId=2103450 274-245]) to the wires coming out of your teledildonics interface.

=Related Links=

*[http://www.calexotics.com/ California Exotic Novelties Website]
*[http://www.calexotics.com/product.php?PRODUCTID=823 Ring of Passion product page] 


[[Category:DIY Hardware]]
[[Category:Teledildonics]]

Return to RingofPassionMod.

Retrieved from "http://wiki.opendildonics.org/RingofPassionMod"

View source

From Opendildonics.org

Views

Personal tools

Navigation

Search

Toolbox